Posted by2 years agó
In an earlier post, I’ve done a pretty detailed walkthrough of setting up Cleanflight on your flight controller. Back then, even if your board was running Betaflight, you would still set it up through the Cleanflight configurator. Now, however, Betaflight has its own configurator, which is not all too different from the original one, but.
Simply picked up a Táranis QX7 and thé BabyHawk drone. l place the receiver into the quad and have attempted to bind the two. Spent a great deal of time reading and watching videos and I'm either missing something easy or something will be incorrect. It received't bind, I never ever observe a green light on the receiver.
Made a model in the Taranis, set it to Chemical16, transformed on bind (beeping starts) after that while holding down the switch the babyhawk't recipient I attach battery power for energy, and nothing at all binds from generally there.
I made a short video to display what I'm carrying out and the result. https://www.youtubé.com/wátch?v=43tNLrTSxis
The Taranis will be operating OpenTX FW version 2.2 went out with 5-30-2017. At this point, I have strike the new man to the pastime wall on servicing more, any recommendations?
3 remarks
Submitted by2 yrs agó
Simply picked up a Táranis QX7 and thé BabyHawk drone. l put the recipient into the quad and possess attempted to bind the two. Spent a great deal of period reading through and watching movies and I'm either lacking something easy or something is certainly wrong. It received't bind, I never ever find a green light on the recipient.
Produced a design in the Taranis, fixed it to N16, flipped on bind (beeping starts) then while keeping down the button the babyhawk't recipient I connect battery power for energy, and nothing binds from right now there.
I made a brief video clip to display what I'm carrying out and the outcome. https://www.youtubé.com/wátch?v=43tNLrTSxis
The Taranis is definitely running OpenTX FW edition 2.2 dated 5-30-2017. At this stage, I have strike the fresh man to the pastime walls on servicing more, any recommendations?
3 comments